- #PET U AUTOMATIC FEEDER INSTALL#
- #PET U AUTOMATIC FEEDER MANUAL#
Make sure to check the level of food regularly to ensure the feeder is dispensing food properly. Always turn the unit off before cleaning. Always keep fingers, hands, and other appendages clear of the internal food wheel to prevent accidents or injuries. Only use this feeder indoors, in a dry place, and on solid, even ground. Improper use or mishandling could also result in permanent damage to your device. Improper usage could result in your pet(s) not being fed properly or not being fed at all. Read all instructions carefully before attempting to operate this device. Properly dispose of all packing materials immediately after unpacking product, as the bags used for packaging could present a suffocation or choking hazard. Please keep all packaging materials out of reach of children and pets. Remove all packaging before using this device. This product contains small parts and is not suitable for children under 3 years old. WARNING: CHOKING HAZARD – Small parts. Exposure to sunlight could damage the internal electronics or cause discoloration be sure the device is placed in a shady place. Make sure all parts of the feeder are completely dry before refilling and re-assembling the device. Three (3) alkaline D batteries should last approximately one (1) year, depending on the quantities and frequency of food being dispensed. If the LOW BATTERY indicator LED starts flashing, replace the batteries in the battery compartment, or connect the feeder to a power adapter. To clean the body, wipe it with a soft cloth and a mild cleaning agent. Do not submerge the body in water this could damage the internal electronics and cause the batteries to short out, create an electrical shock, or catch fire. 
The body of the feeder is not dishwasher-safe.Use only pet-safe cleaning agents and make sure to thoroughly rinse and fully dry the food bucket before replacing it. The internal food container is not dishwasher-safe, but can be removed and cleaned with water and a mild cleaning agent.The feeder bowl is dishwasher-safe for your convenience.Replace the large portion dispenser with the small portion dispenser.Remove the screws holding the portion dispenser wheel in place.Empty and remove the food bucket and flip it upside down.Only use the small portion dispenser with smaller-sized kibble NOTE: Most standard food sizes require the pre-installed large portion dispenser. The LCD display will show the time and portion size for that meal Press and hold the corresponding MEAL button.Repeat until the desired portion has been dispensed.
#PET U AUTOMATIC FEEDER MANUAL#
Press and hold the MANUAL button for three (3) seconds to manually dispense one (1) portion of food.The message will play at each designated meal time. To review your message, press and hold the PLAY button for three (3) seconds.Press and hold the REC button for three (3) seconds until the LCD display starts flashing.Repeat this process with the MEAL and MINUTE buttons to set the minutes if needed. Press HOUR while holding down MEAL to set the hour for that meal to dispense. Set Meal Time: Press and hold the corresponding MEAL and HOUR buttons simultaneously.Refer to the included portion chart to determine your appropriate portion size.
Press AMOUNT while holding down MEAL to adjust the portion size from 1-39.
Set Portion Amount: Press and hold the corresponding MEAL and AMOUNT buttons simultaneously. Toggle Meals ON/OFF: Press and hold the corresponding MEAL and ON/OFF buttons simultaneously to toggle ON/ OFF on the display, indicating whether or not the pet is being fed that specific meal. 
Repeat the same process for the minutes using the TIMER and MINUTE buttons. While holding down the TIMER button, press the HOUR button to cycle forward until you reach the correct hour. Press and hold the TIMER and HOUR buttons simultaneously until the numbers start flashing. If it completes successfully, then the motor functions are working with no issues. The rotor should rotate and release one portion.Ģ. Press and hold the MANUAL button on the feeder for three (3) seconds. Make sure the power switch is in the on position (“I”). Make sure battery wrappings are not torn and that you match the positive and negative poles with the markings in the compartment. Open the battery compartment at the bottom of the feeder body. #PET U AUTOMATIC FEEDER INSTALL#
If you do not wish to use the power adapter, you may install batteries Install Batteries Plug a USB cord into the USB port at the rear of the main body, and attach the other end to a power adapter.Attach the bowl to the designated notches underneath the main body.Using your New Automatic Feeder Assemble Unit
Large portion dispenser (installed by default).
0 kommentar(er)
